Unlike the competition, The Bullet DVR™ camera is not just a simple camera designed for use in security systems. Our camera has improved features you will not find anywhere else. The whole camera body is made from aircraft-grade aluminum, greatly helping to dissipate internal heat.
The whole camera is fully sealed and waterproof, and attaches to the DVR unit via a strain-reliefed cable for maximum protection. It can be used in the rain, mud or snow without worries of fogging up due to condensation problems.
The output cable features a RCA plug for video, and a 2.1mm DC connector for powering up the camera off any 12VDC source.
The optical lens is secured behind a clear protective glass, housed inside and removable cap which allows you to swap the standard 3.6mm lens (92 degrees angle-of-view) for one of the many optional lenses available, to better suit your requirements. The O-ring tight compartment makes it a breeze to change the lens without the need for any special tools.
The back housing of the camera features a strain-relief video cable, in place of the traditional tripod mount found on other bullet cameras. The tripod mount leaves no room for the output cable, which means the cable is located at the very edge of the camera body, resulting too often in a pinched or cut cable when not just pulled out entirely from the enclosure. The Bullet DVR™ camera improves on this very weak point by replacing the not-required tripod mount for a much needed pull-resistant feature.
Our cameras can be ordered with various CCD image sensors, which provide various output resolutions and perform differently in low light conditions. The standard camera is the 450TVL version, which performs good under normal conditions. You can upgrade it to one of our other versions (up to 580 TV lines), to better suit your requirements. Refer to the chart for a comparison of our many cameras, and to choose the one which will work best for your needs:
Click Here To See The Model Chart